The Power of BoilerMag

A large hydronic system was installed with all non-barrier tubing that had previously only had a y-strainer. The user drained the old system before refilling and on startup still found it was full of debris. A BoilerMag XL was installed to remove all this damaging magnetite. During the first two cleans, the BoilerMag XL filter was covered with black sludge and debris. By the third clean, the filter barely had any collected contamination, leaving the owner with a clean, efficient system.

The BoilerMag rule of thumb for cleaning is one day, one week, one month. This means, that a BoilerMag should be cleaned the day after it has been installed to gauge the levels of system contaminants. Then one week after that, and then again in a month, until the system is clean.

BoilerMag XL is a highly efficient filter system which effectively removes both harmful magnetic and non-magnetic debris on the first pass, protecting your boiler and ensuring full efficiency of all hydronics systems. The BoilerMag XL non block design utilizes a unique patented magnetic field to ensure the unit does not block, no matter the level of contamination.

The picture below shows how much contamination was captured from the BoilerMag.

Imagine just how much damage this would have done circulating through this new system!

Located in Hartland, WI.
Thank you, Mitch Sherman from Sherman Plumbing Heating & Air, for sharing!